Follow

Quick Set Tree Set Up

Quick set trees are the quickest and easiest Christmas tree to assemble. Quick set trees are a new technology introduced Christmas 2012.

Step 1

Remove parts from the box. Reference the user manual to ensure that all required parts are accounted for. If you are missing parts, contact Polygroup customer service at 1-888-919-0070.

Step 2

Assemble stand on a level surface near a wall outlet, allowing for space by measuring diameter listed on box.

Metal Wire Stand: Assemble by pulling into an “X” shape with 90-degree angles.

 

 

Sheet Metal Stand: Unfold the legs and lay the stand flat, then slide the locking disc downward and snap into place. Some metal stands also require a slight turn to lock the disc.

 

 

Plastic Stand: Insert plastic legs into the grooves in the stand center. Make sure the stand is stable after the legs are installed.

 

Rotating Stand: Follow the below instructions.

Step 3

Remove the protective caps from the tree bottom section. Insert the pole into the tree stand. Continue removing caps and fitting the next section into the first until all sections are assembled. Shape the branches working from the bottom up. For more information on shaping/fluffing the tree, please see Fluffing-and-Shaping your tree. Ensure all wires are free of hinges.

Step 4

Insert the green label extension cord plug into the wall outlet. All your lights should be illuminated. If the lights aren't working, please refer to the troubleshooting tips on tree lights.

Quick Set Tree Setup Diagram:                    

 

      

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments

Powered by Zendesk